SPS-1 Configuration Tool

Idle | Firmware Version: —

IMPORTANT: SET SWITCH must be set to 0 for updated settings to remain in effect after SPS is power cycled. DCN ADDR Switch must be set to 0 for EEPROM DCN Address to be in effect after power is cycled.

Live State

Input Voltage—
Switch Current—
Power Request—
Power Switch—
Fault—
OC Retries—
Watchdog—
DCN ADDR Switch—
SET Switch—

Voltage Limits

Mobile Mode (Auto Power Off/On voltage and timeout settings)

6 8 10 12 14 16 18
Voltage Limits and Thresholds

Overcurrent Protection

Switch Configuration

DCN Address Configuration

Calibration (CALSET)

⚠ CALSET parameters should match the factory-provided values and only be changed if the original values were corrupted. These values directly affect the overcurrent trip point. Setting them incorrectly may allow damage to connected equipment.

Logs

Total ON Time—
Undervoltage Trips—
Overvoltage Trips—
Overcurrent Trips—

Firmware Update (Only available for firmware versions 2.0 and later)

Flash a new firmware image into the SPS-1 over this serial port using the bootloader. The device must be in bootloader mode (DCN ADDR switch at F, power-cycled after) before starting.

Serial Trace